Difference between revisions of "Wifi-Link"
| Line 35: | Line 35: | ||
{| | {| | ||
|'''VCC''' | |'''VCC''' | ||
| − | : | + | |style="width: 30%"|Positive powering lead: 3.3V – 15V |
|- | |- | ||
|'''GND''' | |'''GND''' | ||
| − | : | + | |style="width: 30%"|Ground powering lead |
|- | |- | ||
|'''RX''' | |'''RX''' | ||
| − | : | + | |style="width: 30%"|Communication lead; SYS port |
|- | |- | ||
|'''TX''' | |'''TX''' | ||
| − | : | + | |style="width: 30%"|Communication lead; SYS port |
|} | |} | ||
Revision as of 12:32, 9 January 2017
1 FEATURES
Power supply: 3.3V - 15V
Weight: 7g
Dimension: 21x32x5.5mm
Operating range: up to 50 meters
Modes: AP, AP+Client, Client
Standard: 802.11b/g/n
Encryption: Open, WEP, WPA, WPA2
Configuration: Web Interface
Power consumption: 80 – 350mA
Supported devices:
- Android (available on the Google Play)
- All smartphones, tablets, smart TV with Web Browser
- PC
- Mac
Support for Firmware Updates.
Web based Spirit Settings app in the module!
2 CONNECTION
Wire Meaning
| VCC | Positive powering lead: 3.3V – 15V |
| GND | Ground powering lead |
| RX | Communication lead; SYS port |
| TX | Communication lead; SYS port |
NOTE
TX wire must be always closer to the SYS label RX wire must be always in the center pin of the SYS port
VCC and GND can be connected to any port, except ELE/PIT/AIL and SYS. It can be connected to a receiver port too. If powered from a separate battery, GND must be connected with the unit's power source.
Do not connect communication cable to the power supply! It can be connected only to the SYS port.
