Difference between revisions of "Translations:GeoLink Configuration/14/en"

From Spirit System Manual
Jump to: navigation, search
(Importing a new version from external source)
 
(Importing a new version from external source)
Line 1: Line 1:
−
#On the following power up of the model you will immediately notice 3 series of rapid LED flashing on the GeoLink.
+
#During following power up of the model you will immediately notice 3 series of rapid LED flashing on the GeoLink. This always signalize module is in the Calibration mode.
 
#The Status LED will be indicating progress of the calibration then. Start moving with the model in all possible directions and angles to mimic a sphere. Any LED flash will indicate that a new calibration data were acquired.
 
#The Status LED will be indicating progress of the calibration then. Start moving with the model in all possible directions and angles to mimic a sphere. Any LED flash will indicate that a new calibration data were acquired.
 
#Rotate with the module as long until you will see periodic LED flashing. At this point the calibration is finished. After following re-power the module is ready for operation.
 
#Rotate with the module as long until you will see periodic LED flashing. At this point the calibration is finished. After following re-power the module is ready for operation.

Revision as of 21:05, 15 January 2021

Information about message (contribute)
This message has no documentation. If you know where or how this message is used, you can help other translators by adding documentation to this message.
Message definition (GeoLink Configuration)
#During following power up of the model you will immediately notice 3 series of rapid LED flashing on the GeoLink. This always signalize module is in the Calibration mode.
#Blue GeoLink LED will be indicating progress of the calibration. GeoLink v2 will light up also Green LED when calibration is ongoing.
#Start moving with the model in all possible directions and angles to mimic a sphere. When Blue LED will flash then it will indicate a new calibration data were acquired.
#Rotate with the module as long until you will see periodic Blue LED flashing. At this point the calibration is finished. Green LED light of the GeoLink v2 will be turned Off. After following re-power the module is ready for operation.
Translation#During following power up of the model you will immediately notice 3 series of rapid LED flashing on the GeoLink. This always signalize module is in the Calibration mode.
#The Status LED will be indicating progress of the calibration then. Start moving with the model in all possible directions and angles to mimic a sphere. Any LED flash will indicate that a new calibration data were acquired.
#Rotate with the module as long until you will see periodic LED flashing. At this point the calibration is finished. After following re-power the module is ready for operation.
  1. During following power up of the model you will immediately notice 3 series of rapid LED flashing on the GeoLink. This always signalize module is in the Calibration mode.
  2. The Status LED will be indicating progress of the calibration then. Start moving with the model in all possible directions and angles to mimic a sphere. Any LED flash will indicate that a new calibration data were acquired.
  3. Rotate with the module as long until you will see periodic LED flashing. At this point the calibration is finished. After following re-power the module is ready for operation.
Retrieved from "https://manual.spirit-system.com/index.php?title=Translations:GeoLink_Configuration/14/en&oldid=47550"