Difference between revisions of "Futaba"
From Spirit System Manual
| Line 11: | Line 11: | ||
<br /> | <br /> | ||
| − | ✔Flight Modes | + | ✔Flight Modes<br /> |
| − | ✔Gyro Gains | + | ✔Gyro Gains<br /> |
| − | ✔Normal (Rate) mode | + | ✔Normal (Rate) mode<br /> |
| − | ✔Rescue and Stabiilsation | + | ✔Rescue and Stabiilsation<br /> |
| − | ✔Bank Switching | + | ✔Bank Switching<br /> |
== Flight style setup == | == Flight style setup == | ||
| Line 21: | Line 21: | ||
'''Go to MDL → CONDITION''' | '''Go to MDL → CONDITION''' | ||
| − | + | Set the Flight mode switch SE for IDLEUP1 and IDLEUP2. | |
:* Make sure that ON/OFF for IDLEUP1 is configured in the following way: | :* Make sure that ON/OFF for IDLEUP1 is configured in the following way: | ||
::OFF | ::OFF | ||
| Line 33: | Line 33: | ||
:*IDLEUP3 will be used for the Rescue/Stabilisation modes. For this purpose we will create special flight mode that will be activated when momentary switch SH is pressed. | :*IDLEUP3 will be used for the Rescue/Stabilisation modes. For this purpose we will create special flight mode that will be activated when momentary switch SH is pressed. | ||
| + | :Configure SH switch for IDLEUP3 with following ON/OFF: | ||
| + | ::OFF | ||
| + | ::ON | ||
| + | |||
| + | :* Hold can be configured for SF switch with ON/OFF values: | ||
| + | ::OFF | ||
| + | ::ON | ||
| + | |||
| + | Final CONDITION screen after the settings: | ||
| + | |||
| + | Check priorities for correct behavior – Hold has the highest priority. | ||
| + | |||
| + | '''Remember to set Throttle and Pitch Curves for NORMAL, IDLEUP1, IDLEUP2 and IDLEUP3 modes.''' | ||
| + | |||
| + | For IDLEUP3 configure higher RPM if you wish to use the rescue mode, because after activation, throttle curve will be changed too. | ||
Revision as of 16:44, 9 January 2017
Setup guide
for
T8FG or compatible
✔Flight Modes
✔Gyro Gains
✔Normal (Rate) mode
✔Rescue and Stabiilsation
✔Bank Switching
Flight style setup
Go to MDL → CONDITION
Set the Flight mode switch SE for IDLEUP1 and IDLEUP2.
- Make sure that ON/OFF for IDLEUP1 is configured in the following way:
- OFF
- ON
- OFF
- For IDLEUP2 it should be as following:
- OFF
- OFF
- ON
- IDLEUP3 will be used for the Rescue/Stabilisation modes. For this purpose we will create special flight mode that will be activated when momentary switch SH is pressed.
- Configure SH switch for IDLEUP3 with following ON/OFF:
- OFF
- ON
- Hold can be configured for SF switch with ON/OFF values:
- OFF
- ON
Final CONDITION screen after the settings:
Check priorities for correct behavior – Hold has the highest priority.
Remember to set Throttle and Pitch Curves for NORMAL, IDLEUP1, IDLEUP2 and IDLEUP3 modes.
For IDLEUP3 configure higher RPM if you wish to use the rescue mode, because after activation, throttle curve will be changed too.
