Translations:GeoLink Configuration/14/en
From Spirit System Manual
Revision as of 21:05, 15 January 2021 by FuzzyBot (Talk | contribs) (Importing a new version from external source)
- During following power up of the model you will immediately notice 3 series of rapid LED flashing on the GeoLink. This always signalize module is in the Calibration mode.
- The Status LED will be indicating progress of the calibration then. Start moving with the model in all possible directions and angles to mimic a sphere. Any LED flash will indicate that a new calibration data were acquired.
- Rotate with the module as long until you will see periodic LED flashing. At this point the calibration is finished. After following re-power the module is ready for operation.