Translations:GeoLink Configuration/14/en

From Spirit System Manual
Revision as of 21:05, 15 January 2021 by FuzzyBot (Talk | contribs) (Importing a new version from external source)

Jump to: navigation, search
  1. During following power up of the model you will immediately notice 3 series of rapid LED flashing on the GeoLink. This always signalize module is in the Calibration mode.
  2. The Status LED will be indicating progress of the calibration then. Start moving with the model in all possible directions and angles to mimic a sphere. Any LED flash will indicate that a new calibration data were acquired.
  3. Rotate with the module as long until you will see periodic LED flashing. At this point the calibration is finished. After following re-power the module is ready for operation.