Spektrum

Wifi-Link manual </br>for</br>

DX8 or compatible

For PWM and Satellite connection – method 1. (requirement - 6ch radio)

• • Flight Modes
  • Gyro Gains in the transmitter
  • Normal (Rate) mode
  • Rescue or Stabiilsation
  • ∗Bank Switching

∗Bank Switching in this method can be used only with Spektrum DSM2/X satellite and 7ch radio.

1 Flight Mode setup

Go to System Setup → F-Mode Setup

Set the Flight Mode to F Mode switch and Hold flight mode to Elev D/R.

So the flight modes can be switched with F Mode switch on your transmitter, while Hold flight mode will be on the Elev D/R switch. Normally this is unwanted, but we will use Hold flight mode for the Rescue and/or Stabilisation modes. In this configuration we can use benefits of the Hold flight mode, because of higher priority.

Go to Function List → Throttle Cut

Set Sw to Hold switch here. Throttle channel will be configured to 0% when Hold switch is on, so the motor will not spool up. In this case we will not use Hold flight mode so Throttle cut is independent of it and still will work.

Go to Function List → Throttle Curve

Configure your Throttle Curves as you wish for all Flight Modes.

IMPORTANT: For the Hold flight mode we will configure Throttle Curve too! Because we will use this one for the Rescue/Stabilisation we can set for example 90% flat curve or just same one as for other flight modes.

When using Governor we recommend to use flat throttle curves (same value from low to high position). But you should study instructions of the ESC and always configure these curves with respect to it.

1. For Normal (N) you can set for example flat 70%

   For Stunt 1 (1) it can be 80%.

   For Stunt 2 (2) it can be 90%.

   For Hold (H) it can be 90% too.

Throttle Curves are only for a better imagination, each model must be configured individually.

2 Gyro Gain setup

Go to Function List → Gyro

Configure Sw to F Mode. Then set the Gyro Gain for each Flight mode. For Normal the gain is mostly the highest because head speed is the lowest.

So it can look like:

• Normal: 70%
• Stunt 1: 68%
• Stunt 2: 66%
• Hold: -66%

IMPORTANT: Remember to set NEGATIVE Gyro Gain for the Hold flight mode else a special mode will not be activeted! Special mode as the rescue or stabilisation are always activated only when Gyro Gain is negative.

Gyro Gains are only for a better imagination, each model must be configured individually.

To allow the rescue/stabilisation mode you have to set Function parameter in the software, Stabi tab.