Translations:Wiring/30/en
From Spirit System Manual
Revision as of 08:20, 16 September 2016 by FuzzyBot (Talk | contribs) (Importing a new version from external source)
The easiest way you can start connect RUD with Rudder output in the receiver. Then continue with AUX which should be connected to the Gyro Gain channel output. Next, connect the Aileron, Elevator and Pitch (Aileron 2) channels. If you are not sure whether you have the correct output or not, you can plug in one servo and power the unit to verify that your connection is correct. This can be repeated for each servo. The diagnostics tab is very helpful too.
