Difference between revisions of "Coaxial/ru"

From Spirit System Manual
Jump to: navigation, search
(Created page with "Соосный режим - это функционал, который помогает пилоту сохранять положение модели в воздухе. М...")
(Created page with "Режим активируется с передатчика специально назначенным тумблером. Стабилизация работает пок...")
Line 3: Line 3:
 
Соосный режим -  это функционал, который помогает пилоту сохранять положение модели в воздухе. Модель может полностью управляться пилотом, но в отличие от обычного режима полета, модель будет автоматически выравниваться в горизонт.
 
Соосный режим -  это функционал, который помогает пилоту сохранять положение модели в воздухе. Модель может полностью управляться пилотом, но в отличие от обычного режима полета, модель будет автоматически выравниваться в горизонт.
  
You can activate the mode remotely by assigned switch of your transmitter. As long as the switch is in active position, the stabilisation mode will be engaged. Otherwise normal flight mode will be used.
+
Режим активируется с передатчика специально назначенным тумблером. Стабилизация работает пока тумблер в активном положении. В противном случае, полет идет в обычном режиме.
  
 
== Characteristics ==
 
== Characteristics ==

Revision as of 14:20, 17 October 2018

Other languages:
čeština • ‎Deutsch • ‎English • ‎español • ‎français • ‎magyar • ‎italiano • ‎русский

Соосный режим - это функционал, который помогает пилоту сохранять положение модели в воздухе. Модель может полностью управляться пилотом, но в отличие от обычного режима полета, модель будет автоматически выравниваться в горизонт.

Режим активируется с передатчика специально назначенным тумблером. Стабилизация работает пока тумблер в активном положении. В противном случае, полет идет в обычном режиме.

1 Characteristics

  • Upon activation of the Coaxial, the model will attain horizontal level quickly (Skids down or up depending on what is closer).
  • When activated upside down, it will hold in the inverted position.
  • Cyclic stick input from the pilot will tilt the model to a degree which can be configured by Stick priority parameter.
  • Cyclic steering is same as when flying with Coaxial helicopters - helicopter is doing rather slow transitions by a slight tilt.
  • It is perfect for learning basic transitions and stationary hovering.
  • In this mode it is impossible to perform a flips or rolls. This mean that this mode is not suitable for learning acrobatics.
  • Collective pitch and rudder is controlled by the pilot as in a normal flight mode.
  • Highly recommended for beginners due to easy control.

Info.png This mode will not maintain altitude or a spot on position. It can make hovering noticeable easier.

Info.png For rescue of the helicopter we highly recommend to use the Rescue mode instead of stabilisation.

2 Setttings

To make it comfortable for your needs you can set the Direction control rate parameter. This will affect how the pilot can change horizontal level by constant pulling the model to a one side. So that the helicopter will tilt more and more over time.

  • Low values are recommended for beginners - it will not allow to change horizontal position too much.

By changing Stick priority you can change degree of achievable angles, so that at full cyclic input (aileron or elevator) helicopter will be tilted more or less.

  • Values between 4 - 10 are for beginners.