Difference between revisions of "CrossFire CRSF"

From Spirit System Manual
Jump to: navigation, search
Line 11: Line 11:
  
 
RUD port - direct cable between CRSF RX Ch. Out 1
 
RUD port - direct cable between CRSF RX Ch. Out 1
 +
 
AIL pin - wire to CRSF RX Ch. Out 2 signal pin
 
AIL pin - wire to CRSF RX Ch. Out 2 signal pin
  

Revision as of 15:55, 13 August 2022

CrossFire CRSF is protocol designed by Team Blacksheep (TBS) which is supported by all Spirit units except Spirit 1 and micro Spirit. It is for sending all channel data and telemetry at the same time. This mean that you do not have to connect anything else except 4 wires.

There are multiple receivers and satellites with CrossFire CRSF support.

1 Wiring

CRSF-Wiring.jpg

RUD port - direct cable between CRSF RX Ch. Out 1

AIL pin - wire to CRSF RX Ch. Out 2 signal pin

2 Spirit Settings

Now you are ready to power up the unit. If your Power supply is not connected yet, we recommend to connect it to the AUX1, AUX2 and/or CH0 port. Before you can utilize the CrossFire connection, it is important to set the CrossFire CRSF receiver type in the General tab of the software. Please start the Spirit Settings and change the receiver type as displayed on the photo. Then save the settings (e.g. by CTRL+S) or the Backup tab/Unit - Save and restart the unit.

CRSF-settings.png

3 Throttle output

You can connect ESC or Throttle servo directly to the Spirit unit at (AUX/AUX1 port).

4 Radio Integration

Integration support is to be added within following updates.