Difference between revisions of "Graupner SUMD"

From Spirit System Manual
Jump to: navigation, search
Line 37: Line 37:
 
Receiver configuration</translate> ==
 
Receiver configuration</translate> ==
  
B<translate><!--T:11-->
+
<translate><!--T:11-->
y default SUMD transmission is disabled in the HoTT receivers.
+
By default SUMD transmission is disabled in the HoTT receivers.
 
It is necessary to enable it in the ''(F) Function/Telemetry/Setting & Data View'' menu (HoTT MZ series).</translate><br/>
 
It is necessary to enable it in the ''(F) Function/Telemetry/Setting & Data View'' menu (HoTT MZ series).</translate><br/>
 
<translate><!--T:12-->
 
<translate><!--T:12-->

Revision as of 14:13, 1 February 2017

Other languages:
čeština • ‎Deutsch • ‎English • ‎español • ‎français • ‎magyar • ‎italiano • ‎русский

With Graupner HoTT radios you can use fully digital, single-line SUMD protocol. For the connection only normal servo cable is required.

1 Wiring

Connect the cable according the photo. In the unit the cable is in the RUD port. In the receiver it is always the last channel. For GR-12/GR-12L it is output with label "6".

Info.png Please note that the signal wire (Orange) is at the bottom of the receiver.

Sumd-conn.jpg

If you have not connected a power supply, you can connect the BEC cable or 1-2S LiPol now (even without a servos).

Warning.png Never connect a power supply to the SYS or ELE/PIT/AIL ports!

2 Spirit Settings

After initialization of the unit you can start the software. To allow the connection set the Receiver type to SRXL/SUMD in the General tab.

Sumd-settings.png

Now save the settings (CTRL+S) or in the Backup tab/Unit - Save.

3 Receiver configuration

By default SUMD transmission is disabled in the HoTT receivers. It is necessary to enable it in the (F) Function/Telemetry/Setting & Data View menu (HoTT MZ series).
Change SUMD at CH6 to YES.

Sumd-rx.jpg

4 Usage

Now you can restart the unit. After the initialization the SUMD connection will work. Reverse of some channels might be necessary depending on the radio model - please check the Diagnostic tab.

The transmission is able to carry all the channels. Usually SUMDOF12 option (if available) is fine.

Info.png For MX-12/MZ-12 transmitters it is needed to change the channel mapping in the Spirit Settings. Please go to the General tab/Channels and change Gyro Gain to Channel 7.