Difference between revisions of "Graupner SUMD/ru"

From Spirit System Manual
Jump to: navigation, search
(Created page with "Если вы еще не подключали питание, подключите BEC или 1-2S Lipo.")
(Created page with "Никогда не подключайте питание к портам SYS и ELE/PIT/AIL!")
Line 12: Line 12:
 
Если вы еще не подключали питание, подключите BEC или 1-2S Lipo.
 
Если вы еще не подключали питание, подключите BEC или 1-2S Lipo.
  
{{Quote|'''Never connect a power supply to the SYS or ELE/PIT/AIL ports!'''}}
+
{{Quote|'''Никогда не подключайте питание к портам SYS и ELE/PIT/AIL!'''}}
  
 
== Spirit Settings ==
 
== Spirit Settings ==

Revision as of 10:16, 19 October 2018

Other languages:
čeština • ‎Deutsch • ‎English • ‎español • ‎français • ‎magyar • ‎italiano • ‎русский

С передатчиком Graupner HoTT вы можете использовать однопроводное цифровое подключение SUMD. Для соединения можно использовать обычный сервокабель.

1 Подключение

Подсоедините кабель как на фото. В Spirit в порт RUD, в приемнике в последний канал. Для GR-12/GR-12L он подписан 6

Info.png Имейте ввиду, что сигнальный провод оранжевого цвета ближе к верхней части приемника.

Sumd-conn.jpg

Если вы еще не подключали питание, подключите BEC или 1-2S Lipo.

Warning.png Никогда не подключайте питание к портам SYS и ELE/PIT/AIL!

2 Spirit Settings

After initialization of the unit you can start the software. To allow the connection set the Receiver type to SRXL/SUMD in the General tab.

Sumd-settings.png

Now save the settings (CTRL+S) or in the Backup tab/Unit - Save.

3 Receiver configuration

By default SUMD transmission is disabled in the HoTT receivers. It is necessary to enable it in the (F) Function/Telemetry/Setting & Data View menu (HoTT MZ series).
Change SUMD at CH6 to YES.

Sumd-rx.jpg

4 Usage

Now you can restart the unit. After the initialization the SUMD connection will work. Reverse of some channels might be necessary depending on the radio model - please check the Diagnostic tab.

The transmission is able to carry all the channels. Usually SUMDOF12 option (if available) is fine.

Info.png For MX-12/MZ-12 transmitters it is needed to change the channel mapping in the Spirit Settings. Please go to the General tab/Channels and change Gyro Gain to Channel 7.