Difference between revisions of "SPM4649T"

From Spirit System Manual
Jump to: navigation, search
(Marked this version for translation)
 
Line 55: Line 55:
 
[[File:Spektrum-settings.png|thumb|center]]
 
[[File:Spektrum-settings.png|thumb|center]]
  
== <translate>Radio Integration</translate> ==
+
== <translate><!--T:83-->
 +
Radio Integration</translate> ==
  
<translate>If you want to use Integration and Telemetry features please continue with [[Spektrum Integration]] page.</translate>
+
<translate><!--T:84-->
 +
If you want to use Integration and Telemetry features please continue with [[Spektrum Integration]] page.</translate>

Latest revision as of 22:00, 30 January 2020

SPM4649T is telemetry enabled receiver that is able to transfer all channel data and telemetry at the same time. This mean that you will not need to connect anything else except one cable.

By using the Jeti integration cable you will not need any additional modification to the receiver. In case you do not have this cable, you can make one easily with a needle and a spare servo plug.

Jeti-cable.jpg

Info.png In case that your SPM4649T receiver is not bound yet, you can do so by a Bind plug. Connect the Bind plug to the servo socket. Then power up the receiver (you can use BEC power supply and/or free port in the unit such as CH0 or AUX2). Optional satellites can be bound normally as described in the Manual.


SPM4649T receiver Jeti integraction cable must be connected to the Servo socket. This socket is used also for Binding.
Spirit unit Other end of the Jeti integration cable should be connected so that Orange wire is in the AIL pin. Powering plug with Red and Brown wires in the RUD port. (see the photo)

SPM4649T receiver Spirit Pro unit


1 Spektrum satellites (optional)

To improve receiving capabilities you can connect additional Spektrum satellites. So the combination can be following:

  • Spirit 2 - 1x SPM4649T + 0-2x Spektrum satellites
  • Spirit Pro - 1x SPM4649T + 0-2x Spektrum satellites
  • Spirit - 1x SPM4649T + 0-1x Spektrum satellites
  • µSpirit - 1x SPM4649T + 0-1x Spektrum satellites

Info.png In case that the ESC telemetry is used, the primary satellite can't be connected. For the Castle Creations and Kontronik Kosmik/Jive Pro ESC telemetry primary satellite can be still used.

2 Spirit Settings

Now you are ready to power up the unit. If your Power supply is not connected yet, we recommend to connect it to the AUX1, AUX2 and/or CH0 port. Before you can utilize the Spektrum integration connection, it is important to set the Spektrum DSM2/X receiver type in the General tab of the software. Please start the Spirit Settings and change the receiver type as displayed on the photo. Then save the settings (e.g. by CTRL+S) or the Backup tab/Unit - Save and restart the unit.

Spektrum-settings.png

3 Radio Integration

If you want to use Integration and Telemetry features please continue with Spektrum Integration page.