SPM4649T

From Spirit System Manual
Revision as of 07:38, 3 February 2020 by Gstatopen (Talk | contribs) (Created page with "Если ваш приемник SPM4649T еще не связан, это можно сделать перемычкой для связывания. Подключите е...")

Jump to: navigation, search

SPM4649T это приемник с поддержкой телеметрии, который позволяет передавать одновременно значения каналов и данные телеметрии. Это значит, что вам не потребуется подключат дополнительные кабели.

Используя Кабель интеграции Jeti вам не потребуется никаких дополнительных изменений в приемнике. Если у вас нет кабеля, его не сложно сделать самостоятельно используя дополнительный серворазъем.

Jeti-cable.jpg

Info.png Если ваш приемник SPM4649T еще не связан, это можно сделать перемычкой для связывания. Подключите ее в серворазъем. Затем подайте питание на приемник ( можно использовать BEC и/или свободный порт Спирита CH0 или AUX2). Дополнительный сателлит можно связать обычным образом как описано Manual.


SPM4649T receiver Jeti integraction cable must be connected to the Servo socket. This socket is used also for Binding.
Spirit unit Other end of the Jeti integration cable should be connected so that Orange wire is in the AIL pin. Powering plug with Red and Brown wires in the RUD port. (see the photo)

SPM4649T receiver Spirit Pro unit


1 Spektrum satellites (optional)

To improve receiving capabilities you can connect additional Spektrum satellites. So the combination can be following:

  • Spirit 2 - 1x SPM4649T + 0-2x Spektrum satellites
  • Spirit Pro - 1x SPM4649T + 0-2x Spektrum satellites
  • Spirit - 1x SPM4649T + 0-1x Spektrum satellites
  • µSpirit - 1x SPM4649T + 0-1x Spektrum satellites

Info.png In case that the ESC telemetry is used, the primary satellite can't be connected. For the Castle Creations and Kontronik Kosmik/Jive Pro ESC telemetry primary satellite can be still used.

2 Spirit Settings

Now you are ready to power up the unit. If your Power supply is not connected yet, we recommend to connect it to the AUX1, AUX2 and/or CH0 port. Before you can utilize the Spektrum integration connection, it is important to set the Spektrum DSM2/X receiver type in the General tab of the software. Please start the Spirit Settings and change the receiver type as displayed on the photo. Then save the settings (e.g. by CTRL+S) or the Backup tab/Unit - Save and restart the unit.

Spektrum-settings.png

3 Radio Integration

If you want to use Integration and Telemetry features please continue with Spektrum Integration page.