Difference between revisions of "Spirit RPM Sensor/cs"
(Created page with "Červený vodič: 3.3V - 15V") |
(Created page with "Hnědý vodič: Zem (GND/-)") |
||
| Line 10: | Line 10: | ||
: Orange wire: RPM Output Signal | : Orange wire: RPM Output Signal | ||
: Červený vodič: 3.3V - 15V | : Červený vodič: 3.3V - 15V | ||
| − | : | + | : Hnědý vodič: Zem (GND/-) |
Revision as of 13:31, 5 July 2022
This sensor is HALL type which senses RPM by motion of the rotating magnets. Usually 1 - 2 neodymium magnets are mounted on the fan of combustion helicopters with a Nitro motor.
- Wire layout
- Orange wire: RPM Output Signal
- Červený vodič: 3.3V - 15V
- Hnědý vodič: Zem (GND/-)
1 Wiring Example
Powering Lead with Red and Brown wires can be plugged to any free port with a BEC voltage. Signal Lead with Orange wire must be plugged always at the middle Pin of the ELE/PIT/AIL port (Spirit 1, Spirit Pro, Spirit 2, Spirit GT) or EXT/RPM/E2 port (Spirit RS and Spirit GTR).
2 Magnet mounting
We highly recommend to orientate each magnet as Active for a proper operation. More magnets will result in a higher reading resolution thus increased readout precision.
3 Governor Settings
When sensor is connected you can optionally use Spirit Governor. Please set the Sensor Divider parameter so that the value will represent count of the active magnets. Usually it is 1 or 2 magnets.
