Difference between revisions of "TelMe Telemetry"

From Spirit System Manual
Jump to: navigation, search
Line 25: Line 25:
 
Servo connector of the Telem KONTRONIK v2 cable should be connected to the ESC. In case of Kontronik KOSMIK you can select any free port.</translate>
 
Servo connector of the Telem KONTRONIK v2 cable should be connected to the ESC. In case of Kontronik KOSMIK you can select any free port.</translate>
  
[[File:esc-hw.jpg|350px]]
+
[[File:esc-kontronik.jpg|350px]]
  
 
== Spirit Settings ==
 
== Spirit Settings ==
Line 41: Line 41:
 
Go to the '''Advanced/Telemetry settings''' and set the '''Kontronik TelMe''' option.</translate>
 
Go to the '''Advanced/Telemetry settings''' and set the '''Kontronik TelMe''' option.</translate>
  
[[File:esc-telem-hw.png|400px]]
+
[[File:esc-telem-telme.png|400px]]
  
 
<translate><!--T:11-->
 
<translate><!--T:11-->

Revision as of 14:31, 10 December 2018

Other languages:
čeština • ‎Deutsch • ‎English • ‎magyar • ‎italiano • ‎русский

Kontronik ESCs are utilizing special 5-pin port connector for telemetry data transmission to the unit. To allow the ESC telemetry, it is necessary to have updated ESC to at least 1.13 firmware version. Older versions do not support TelMe protocol.

1 Telemetry Cable

To allow the telemetry data transmission the Telem KONTRONIK v2 cable is required. This cable is available in our Eshop.

Telemkontronikv2.png

Warning.png We do not recommend to make this cable at home since improper connection will cause permanent damage of the unit.

2 Interfacing

Connect the Telemetry cable to the primary Spektrum satellite port in the unit. Smaller Spirit units will utilize the one native Spektrum satellite port (μSpirit - SAT port).

Unit-telemuni.jpg

Servo connector of the Telem KONTRONIK v2 cable should be connected to the ESC. In case of Kontronik KOSMIK you can select any free port.

Esc-kontronik.jpg

3 Spirit Settings

Power up the ESC and start the Spirit Settings as usually.

3.1 Telemetry activation

As the last step you have to set the ESC Telemetry in the Spirit Settings software.

Go to the Advanced/Telemetry settings and set the Kontronik TelMe option.

Esc-telem-telme.png

Then close the window and save the settings (CTRL+S). Finally, reconnect battery from the ESC.

From this moment, everything should work.

4 Displaying telemetry data

You can display telemetry data directly in your radio from now.

How to display the data is described in the integration guides:

5 Supported models