Difference between revisions of "Translations:Configuration/341/en"
From Spirit System Manual
(Importing a new version from external source) |
(Importing a new version from external source) |
||
| Line 1: | Line 1: | ||
The value should be configured to match with 100% throttle output programmed in your ESC or full throttle of the motor. If this parameter is not high enough you will be unable to tune Governor because there will be not enough room to compensate high loads. | The value should be configured to match with 100% throttle output programmed in your ESC or full throttle of the motor. If this parameter is not high enough you will be unable to tune Governor because there will be not enough room to compensate high loads. | ||
| − | If configured too high then you can observe that after high load head speed will not drop immediately but can be there even for few seconds | + | If configured too high then you can observe that after high load head speed will not drop immediately but can be there even for few seconds. |
Latest revision as of 11:24, 4 October 2016
The value should be configured to match with 100% throttle output programmed in your ESC or full throttle of the motor. If this parameter is not high enough you will be unable to tune Governor because there will be not enough room to compensate high loads. If configured too high then you can observe that after high load head speed will not drop immediately but can be there even for few seconds.
