Translations:GeoLink Configuration/14/en

From Spirit System Manual
Revision as of 13:21, 6 September 2022 by FuzzyBot (Talk | contribs) (Importing a new version from external source)

(diff) ← Older revision | Latest revision (diff) | Newer revision → (diff)
Jump to: navigation, search
  1. During following power up of the model you will immediately notice 3 series of rapid LED flashing on the GeoLink. This always signalize module is in the Calibration mode.
  2. Blue GeoLink LED will be indicating progress of the calibration. GeoLink v2 will light up also Green LED when calibration is ongoing.
  3. Start moving with the model in all possible directions and angles to mimic a sphere. When Blue LED will flash then it will indicate a new calibration data were acquired.
  4. Rotate with the module as long until you will see periodic Blue LED flashing. At this point the calibration is finished. Green LED light of the GeoLink v2 will be turned Off. After following re-power the module is ready for operation.
Retrieved from "https://manual.spirit-system.com/index.php?title=Translations:GeoLink_Configuration/14/en&oldid=51249"