From Spirit System Manual
|
|
Line 4: |
Line 4: |
| #Open ''General tab - GeoLink module'' settings. | | #Open ''General tab - GeoLink module'' settings. |
| #Move to the ''Module tab'' there. | | #Move to the ''Module tab'' there. |
− | #Place GeoLink at a flat, aligned horizontal surface anywhere on your model in order to get a precise reference. (for example the Spirit unit) | + | #Place GeoLink at a flat, aligned horizontal surface anywhere at your model in order to get a precise reference. (for example the Spirit unit) |
| #Click '''Set as zero (temporarily)''' button to reset angle of built-in protractor. | | #Click '''Set as zero (temporarily)''' button to reset angle of built-in protractor. |
| #Move GeoLink to a desired mounting position. | | #Move GeoLink to a desired mounting position. |
| #Mount it with provided double sided tape at position ideally with 0° deflection. | | #Mount it with provided double sided tape at position ideally with 0° deflection. |
Latest revision as of 01:29, 16 January 2022
- Connect GeoLink and Spirit unit with provided cable (while GeoLink being not mounted yet).
- Power up the Spirit unit.
- After initialization start the Spirit Settings software.
- Open General tab - GeoLink module settings.
- Move to the Module tab there.
- Place GeoLink at a flat, aligned horizontal surface anywhere at your model in order to get a precise reference. (for example the Spirit unit)
- Click Set as zero (temporarily) button to reset angle of built-in protractor.
- Move GeoLink to a desired mounting position.
- Mount it with provided double sided tape at position ideally with 0° deflection.