Difference between revisions of "YGE Telemetry/cs"

From Spirit System Manual
Jump to: navigation, search
(Created page with "Zapnutí telemetrie")
(Created page with "V posledním kroku nastavte ESC telemetrii v programu Spirit Settings.")
Line 34: Line 34:
 
=== Zapnutí telemetrie ===
 
=== Zapnutí telemetrie ===
  
As the last step you have to set the ESC Telemetry in the Spirit Settings software.
+
V posledním kroku nastavte ESC telemetrii v programu Spirit Settings.
  
 
Go to the '''Advanced/Telemetry settings''' and set the '''YGE LVT/HVT''' option.
 
Go to the '''Advanced/Telemetry settings''' and set the '''YGE LVT/HVT''' option.

Revision as of 16:44, 4 August 2018

Other languages:
čeština • ‎Deutsch • ‎English • ‎español • ‎français • ‎magyar • ‎italiano • ‎русский

Regulátory YGE LVT a YGE HVT zasílají telemetrii pomocí programovacího portu. Tímto je zprostředkován přenos dat až do jednotky. Pro fungování ESC telemetrie je nezbytné mít aktuální verzi firmware v regulátoru otáček. Starší verze firmware tuto podporu nemají.

1 Telemetrická propojka

Telemtrické data je možné přenášet skrze propojku JST-Servo. Je dostupná na našem Eshopu.

Jst-servo.png

Warning.png It is very important to modify the cable correctly, otherwise permanent damage of the Spirit unit will occur!

1.1 Úprava propojky

Extremely important is the following Modification of the JST-Servo adapter cable. It is required to unplug or cut RED wire of the adapter as displayed at the photo.

Jst-servo-mod.png

2 Zapojení

Zapojte upravený kablík JST-Servo do primárního portu pro Spektrum satelit. U menších jednotek Spirit se použije nativní port pro satelit Spektrum (μSpirit - SAT port).

Unit-telemuni.jpg

Servo konektor propojky JST-Servo musí být spojen s modrým servo konektorem regulátoru YGE.

Esc-yge.jpg

3 Spirit Settings

Připojte baterii k regulátoru a spusťte konfigurační program Spirit Settings běžným způsobem.

3.1 Zapnutí telemetrie

V posledním kroku nastavte ESC telemetrii v programu Spirit Settings.

Go to the Advanced/Telemetry settings and set the YGE LVT/HVT option.

Esc-telem-yge.png

Then close the window and save the settings (CTRL+S). Finally, reconnect battery from the ESC.

From this moment, everything should work.

4 Displaying telemetry data

You can display telemetry data directly in your radio from now.

How to display the data is described in the integration guides:

5 Supported models

Model

Battery Voltage

Battery Current

Consumed Capacity

ESC Temperature

RPM

YGE 35LVT
YGE 65LVT
YGE 95LVT
YGE 135LVT
YGE 90HVT Opto
YGE 120HVT Opto
YGE 165HVT Opto
YGE 205HVT