Rescue (Acro) - Revision history

Spiritdm: Marked this version for translation

2017-02-21T08:34:16Z

Marked this version for translation

Spiritdm at 08:33, 21 February 2017

2017-02-21T08:33:34Z

Admin at 11:54, 25 January 2017

2017-01-25T11:54:19Z

Admin at 10:18, 25 January 2017

2017-01-25T10:18:43Z

Admin at 10:17, 25 January 2017

2017-01-25T10:17:11Z

Admin: Created page with "The Rescue mode is used for model recovery from a situations where the pilot is unable to control it with a confidence. The Rescue, so called ''Bailout'' is activated by the p..."

2017-01-25T10:12:15Z

Created page with "The Rescue mode is used for model recovery from a situations where the pilot is unable to control it with a confidence. The Rescue, so called ''Bailout'' is activated by the p..."

New page

The Rescue mode is used for model recovery from a situations where the pilot is unable to control it with a confidence.
The Rescue, so called ''Bailout'' is activated by the pilot remotely with a preferred switch on the transmitter.
During normal flight it should be inactive.

Whenever it is needed, the pilot can hold a switch or a button which will engage the recovery. As long as the switch is in active position, the Rescue will be engaged too. Immediately after returning a switch/button to inactive position, the pilot will get full control of the model again.

== Characteristics ==
Upon activation of the Rescue (Acro) the model will perform the following:
#Collective pitch will be set automatically to allow ascending (depending on the ''Rescue collective'' parameter).
#Model will rotate as fast as possible to recover the Horizontal position (depending on the ''Cyclic Ring'' settings).
#The model will ascend in position which is closer (inverted or skids down).
#The model will ascend as long as the mode is active.

{{Quote|Due to high demands for a power supply (BEC) it is recommended to verify that it can handle high current spikes! These will occur in the moment of activation. You can use the BEC Tester built-in in the Spirit Settings software.}}
<p></p>
{{Quote|Do not set too high angles for the Cyclic pitch (Cyclic Ring - ''Aileron/Elevator Range'' parameter) else the '''boom strike''' may occur! To prevent this, it is recommended to not exceed recommended angles by manufacturer of the model and to maintain moderate head speed.}}

@@ Line 1: / Line 1: @@
 <languages />
 <p></p>
-<translate>The Rescue mode is used for model recovery from a situations where the pilot is unable to control it with a confidence.
+<translate><!--T:1-->
 The Rescue, so called ''Bailout'', is activated by the pilot remotely with a preferred switch on the transmitter.
 During normal flight it should be inactive.</translate>
-<translate>Whenever it is needed, the pilot can hold a switch or a button which will engage the recovery. As long as the switch is in active position, the Rescue will be engaged too. Immediately after returning a switch/button to inactive position, the pilot will get full control of the model again.</translate>
+<translate><!--T:2-->
-<translate>We highly recommend to use a ''momentary switch'', which will return to the original position on its own. Thus it is easy to activate and deactivate the rescue just for a very short period of time.</translate>
+<translate><!--T:3-->
-== <translate>Characteristics</translate> ==
+== <translate><!--T:4-->
-<translate>Upon activation of the Rescue (Acro) the model will perform the following:</translate>
+Characteristics</translate> ==
-#<translate>Collective pitch will be set automatically to allow ascending (depending on the ''Rescue collective'' parameter).</translate>
+<translate><!--T:5-->
-#<translate>Model will rotate as fast as possible to recover the Horizontal position (depending on the ''Cyclic Ring'' settings).</translate>
+Upon activation of the Rescue (Acro) the model will perform the following:</translate>
-#<translate>The model will ascend in position which is closer to the horizontal level (inverted or skids down).</translate>
+#<translate><!--T:6-->
-#<translate>The model will ascend as long as the mode is active.</translate>
+Collective pitch will be set automatically to allow ascending (depending on the ''Rescue collective'' parameter).</translate>
 <p></p>
-{{Info|[[File:Info.png|18px|]] <translate>Pilot have still possibility to control the model - depending on the ''Sticks priority'' value.
+{{Info|[[File:Info.png|18px|]] <translate><!--T:10-->
 Collective pitch will be fully controlled by the unit.</translate>}}
 <p></p>
-{{Quote|<translate>Due to high demands for a power supply (BEC) it is recommended to verify that it can handle high current spikes! These will occur in the moment of activation. You can use the BEC Tester built-in in the Spirit Settings software.</translate>}}
+{{Quote|<translate><!--T:11-->
 <p></p>
-{{Quote|<translate>Do not set too high angles for the Cyclic pitch (Cyclic Ring - ''Aileron/Elevator Range'' parameter) else the '''boom strike''' may occur! To prevent this, it is recommended to not exceed recommended angles by manufacturer of the model and to maintain moderate head speed.</translate>}}
+{{Quote|<translate><!--T:12-->

@@ Line 1: / Line 1: @@
-The Rescue mode is used for model recovery from a situations where the pilot is unable to control it with a confidence.
+<languages />
 The Rescue, so called ''Bailout'', is activated by the pilot remotely with a preferred switch on the transmitter.
-During normal flight it should be inactive.
+During normal flight it should be inactive.</translate>
-Whenever it is needed, the pilot can hold a switch or a button which will engage the recovery. As long as the switch is in active position, the Rescue will be engaged too. Immediately after returning a switch/button to inactive position, the pilot will get full control of the model again.
+<translate>Whenever it is needed, the pilot can hold a switch or a button which will engage the recovery. As long as the switch is in active position, the Rescue will be engaged too. Immediately after returning a switch/button to inactive position, the pilot will get full control of the model again.</translate>
-We highly recommend to use a ''momentary switch'', which will return to the original position on its own. Thus it is easy to activate and deactivate the rescue just for a very short period of time.
+<translate>We highly recommend to use a ''momentary switch'', which will return to the original position on its own. Thus it is easy to activate and deactivate the rescue just for a very short period of time.</translate>
-== Characteristics ==
+== <translate>Characteristics</translate> ==
-Upon activation of the Rescue (Acro) the model will perform the following:
+<translate>Upon activation of the Rescue (Acro) the model will perform the following:</translate>
-#Collective pitch will be set automatically to allow ascending (depending on the ''Rescue collective'' parameter).
+#<translate>Collective pitch will be set automatically to allow ascending (depending on the ''Rescue collective'' parameter).</translate>
-#Model will rotate as fast as possible to recover the Horizontal position (depending on the ''Cyclic Ring'' settings).
+#<translate>Model will rotate as fast as possible to recover the Horizontal position (depending on the ''Cyclic Ring'' settings).</translate>
-#The model will ascend in position which is closer to the horizontal level (inverted or skids down).
+#<translate>The model will ascend in position which is closer to the horizontal level (inverted or skids down).</translate>
-#The model will ascend as long as the mode is active.
+#<translate>The model will ascend as long as the mode is active.</translate>
 <p></p>
-{{Info|[[File:Info.png|18px|]] Pilot have still possibility to control the model - depending on the ''Sticks priority'' value.
+{{Info|[[File:Info.png|18px|]] <translate>Pilot have still possibility to control the model - depending on the ''Sticks priority'' value.
-Collective pitch will be fully controlled by the unit.}}
+Collective pitch will be fully controlled by the unit.</translate>}}
 <p></p>
-{{Quote|Due to high demands for a power supply (BEC) it is recommended to verify that it can handle high current spikes! These will occur in the moment of activation. You can use the BEC Tester built-in in the Spirit Settings software.}}
+{{Quote|<translate>Due to high demands for a power supply (BEC) it is recommended to verify that it can handle high current spikes! These will occur in the moment of activation. You can use the BEC Tester built-in in the Spirit Settings software.</translate>}}
 <p></p>
-{{Quote|Do not set too high angles for the Cyclic pitch (Cyclic Ring - ''Aileron/Elevator Range'' parameter) else the '''boom strike''' may occur! To prevent this, it is recommended to not exceed recommended angles by manufacturer of the model and to maintain moderate head speed.}}
+{{Quote|<translate>Do not set too high angles for the Cyclic pitch (Cyclic Ring - ''Aileron/Elevator Range'' parameter) else the '''boom strike''' may occur! To prevent this, it is recommended to not exceed recommended angles by manufacturer of the model and to maintain moderate head speed.</translate>}}

← Older revision		Revision as of 11:54, 25 January 2017
Line 4:		Line 4:

	Whenever it is needed, the pilot can hold a switch or a button which will engage the recovery. As long as the switch is in active position, the Rescue will be engaged too. Immediately after returning a switch/button to inactive position, the pilot will get full control of the model again.		Whenever it is needed, the pilot can hold a switch or a button which will engage the recovery. As long as the switch is in active position, the Rescue will be engaged too. Immediately after returning a switch/button to inactive position, the pilot will get full control of the model again.
		+
		+	We highly recommend to use a ''momentary switch'', which will return to the original position on its own. Thus it is easy to activate and deactivate the rescue just for a very short period of time.

	== Characteristics ==		== Characteristics ==