Admin: Created page with "Spirit Wave ESC Integration"

2026-07-28T08:52:58Z

Created page with "Spirit Wave ESC Integration"

New page

Spirit Wave is able to configure supported ESCs directly through Modern User Interface.
This mean that not only Telemetry values can be seen at Wave Display but additionally pilot can access also particular ESC settings and change them without any additional programming device.

== Supported ESCs ==

Supported ESCs are subject of a firmware version. With following updates more ESCs will be suppported.

Presently following ESCs are fully supported:

* YGE LVT/HVT series
* HobbyWing v5 series
* XDFly
* Scorpion Tribunus

== Wiring ==

=== YGE LVT/HVT ===

Wiring is identical as for a standard ESC telemetry support with Spirit units. Please visit [[YGE_Telemetry|YGE Telemetery]] page.

'''Requirements:'''
* ESC has to be configured for YGE protocol.

=== HobbyWing v5 ===

Wiring is identical as for a standard ESC telemetry support with Spirit units. Please visit [[HobbyWingV5_Telemetry|HobbyWing v5 Telemetery]] page.

'''Requirements:'''
* Spirit Wave firmware: 1.0.20+
* Spirit firmware: 3.7.3

=== XDFly ===

Wiring require a single cable between '''SAT1 port''' and '''RX pin''' of the ESC.

'''Requirements:'''
* ESC firmware has to be the latest version

== Setup ==

For enabling the Integration you have to enter '''Model - ESC - Type''' page.

[[File:wave-esc-setup.png|550px]] [[File:wave-esc-setup2.png|550px]]

After Saving the settings you can repower the Spirit unit and from then ESC Integration is ready to use.

== Usage ==

For accessing ESC parameters you have to enter '''Model - ESC - ESC Setup''' page. This page is available only if ESC Integration is really working.
This mean ESC Setup might not work because of:
* Wrong Wiring
* Wrong (old) ESC firmware
* Wrong telemetry protocol configured in the ESC.

If you can see no ESC telemetry values then this integration will not work.

=== ESC Setup ===

Parameters can be easily accessed as part of the Wave User Interface without requirement of installing any special tool.

Following screenshots were recorded from HobbyWing v5 configuration interface.

[[File:wave-esc-setup-hw5.png|550px]]

[[File:wave-esc-setup-hw52.png|550px]] [[File:wave-esc-setup-hw53.png|550px]]

[[File:wave-esc-setup-hw54.png|550px]] [[File:wave-esc-setup-hw55.png|550px]]

Spirit Wave ESC Integration/de - Revision history

Admin: Created page with "Spirit Wave ESC Integration"