Spirit Wave FCC - Revision history

Admin at 07:18, 14 November 2024

2024-11-14T07:18:37Z

Admin at 10:22, 13 November 2024

2024-11-13T10:22:57Z

Admin at 08:08, 13 November 2024

2024-11-13T08:08:33Z

Admin at 08:08, 13 November 2024

2024-11-13T08:08:24Z

Admin at 11:54, 24 October 2024

2024-10-24T11:54:28Z

Admin at 11:55, 15 October 2024

2024-10-15T11:55:44Z

Admin at 11:55, 15 October 2024

2024-10-15T11:55:22Z

Admin: Created page with "=6 FCC Compliance Statement= This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi..."

2024-10-14T06:26:16Z

Created page with "=6 <translate>FCC Compliance Statement</translate>= <translate>  This device complies with part 15 of the FCC Rules. Operation is subject to the following two condi..."

New page

=6 <translate>FCC Compliance Statement</translate>=

<translate>

This device complies with part 15 of the FCC Rules. Operation is subject to the following two conditions:


(1) this device may not cause harmful interference, and (2) this device must accept any interference received, including interference that may cause undesired operation.


'''CAUTION''': The grantee is not responsible for any changes or modifications not expressly approved by the party responsible for compliance. Such modifications could void the user’s authority to operate the equipment.


'''NOTE''': This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation. This equipment generates, uses, and can radiate radio frequency energy, and if not installed and used in accordance with the instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
*Reorient or relocate the receiving antenna.
*Increase the separation between the equipment and receiver.
*Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
*Consult the dealer or an experienced radio/TV technician for help.
The device has been evaluated to meet general RF exposure requirement. To maintain compliance with FCC's RF exposure guidelines, the distance must be at least 20 cm between the radiator and your body, and fully supported by the operating and installation.
</translate>

<div class=noprint>
----
{|style="width: 100%;color: white;"
|-
| style="width: 33%;"| [[<translate>Spirit_Wave_Computer</translate>|← <translate>Configuring from computer</translate>]]
| style="width: 33%;text-align:center;"| [[#up|↑<translate>Up</translate>↑]]
| style="text-align:right;" | [[<translate>Spirit_Wave</translate>|<translate>Main page</translate> →]]
|}
----
</div>

@@ Line 18: / Line 18: @@
 *Consult the dealer or an experienced radio/TV technician for help.
-The device has been evaluated to meet general RF exposure requirement. The SAR limit of USA(FCC) is 1.6 W/kg averaged over one gram of tissue. Device types Spirit WAVE with Spirit WAVE '''(FCC ID: 2AW4Z-SRADIO)''' has also been tested against this SAR limit. The highest reported SAR values for body-worn is 0.460W/kg. The Max simultaneous SAR is 0.882W/kg. This device was tested for typical body-worn operations with the back of the handset kept 0mm from the body. The use of accessories that do not satisfy these requirements may not
+The device has been evaluated to meet general RF exposure requirement. The SAR limit of USA(FCC) is 1.6 W/kg averaged over one gram of tissue. Device types Spirit WAVE with Spirit WAVE '''(FCC ID: 2AW4Z-SRADIO)''' has also been tested against this SAR limit. The highest reported SAR values for body-worn is 0.460W/kg. The Max simultaneous SAR is 0.460W/kg. This device was tested for typical body-worn operations with the back of the handset kept 0mm from the body. The use of accessories that do not satisfy these requirements may not
 comply with FCC RF exposure requirements, and should be avoided.
 </translate>

← Older revision		Revision as of 11:54, 24 October 2024
Line 1:		Line 1:
−	=6 <translate>FCC Compliance Statement</translate>=	+	=<translate>FCC Compliance Statement</translate>=

	<translate>		<translate>

@@ Line 20: / Line 20: @@
 </translate>
-'''FCC ID: 2AW4Z-SRADIO'''
+Granted '''FCC ID: 2AW4Z-SRADIO'''
 <div class=noprint>

← Older revision		Revision as of 11:55, 15 October 2024
Line 20:		Line 20:
	</translate>		</translate>

		+	'''FCC ID: 2AW4Z-SRADIO'''

	<div class=noprint>		<div class=noprint>

@@ Line 24: / Line 24: @@
 <div class=noprint>
 ----
 {|style="width: 100%;color: white;"