https://manual.spirit-system.com/index.php?action=history&feed=atom&title=Spirit_Wave_Opening%2Fen 2026-07-22T22:52:02Z Revision history for this page on the wiki MediaWiki 1.26.2 https://manual.spirit-system.com/index.php?title=Spirit_Wave_Opening/en&diff=53939&oldid=prev 2026-07-22T16:58:13Z

<p>Importing a new version from external source</p> <p><b>New page</b></p><div>__NOTOC__<br /> <br /> =Opening and Closing=<br /> <br /> Spirit Wave can be opened and maintained with supplied Screwdrivers.<br /> All screws are Torx type, except for Gimbals.<br /> <br /> {{Info|[[File:Info.png]] Before opening the chasis Power Off the transmitter completely.}}<br /> &lt;p&gt;&lt;/p&gt;<br /> {{Info|[[File:Info.png]] Opening the Chasis, changing Stick or Switch configuration will not lead to a Warranty Loss if done correctly.}}<br /> &lt;p&gt;&lt;/p&gt;<br /> <br /> == Opening Procedure ==<br /> <br /> === Back Cover ===<br /> <br /> Use supplied Torx T6 Key to open the Wave radio. Unscrew 5 screws in Total.<br /> <br /> {{Quote|Plastic Body of the Wave radio has center screw longer! When assembling the chasis make sure to insert it only at this center opening.}}<br /> &lt;br/&gt;<br /> [[File:Wave-Step1.png|900px ]]<br /> <br /> === Two Chasis parts ===<br /> <br /> When all 5 screws were disassembled continue in the following way. Gently move top and bottom parts apart.<br /> <br /> [[File:Wave-Step2.png|750px ]]<br /> <br /> === Opened ===<br /> <br /> As the last step, put front sides carefully near each other. Both parts are interconnected. To maintain connection of all the cables, proceed with the following photo.<br /> <br /> [[File:Wave-Step3.png|900px ]]<br /> <br /> == Closing Procedure ==<br /> <br /> #Arrange both parts of the radio as described at the ''Opened'' section above.<br /> #Make sure all the flat cables are inserted properly at their connectors.<br /> #Make sure Battery and Speaker cables are connected and their connectors are fully inserted.<br /> #Move the Top part of the Wave radio above Bottom part.<br /> #Gently place the Top part to be exactly above Bottom part, so that edges of both parts are parallel.<br /> #Check from each side that there is no cable coming out of the chasis. (From Battery, Speaker or Switches), if so move them inside the body.<br /> #Flip the Radio upside down carefully and insert all 5 screws. For plastic Spirit Wave central screw is longer (8 mm).<br /> #Tighten all 5 screws. Do not overtight them.<br /> <br /> {{Info|[[File:Info.png]] Verify that Gimbals are moving freely in the full extent with no audiable sound. If there is a noise during movement it mean a flat cables are incorrectly placed and interfering with a gimbal mechanics inside. This will require opening, correcting the problem and closing procedure.}}<br /> &lt;p&gt;&lt;/p&gt;</div>

FuzzyBot