Translations:Configuration/481/en - Revision history

FuzzyBot: Importing a new version from external source

2022-09-16T16:27:21Z

Importing a new version from external source

DaniloB at 20:20, 6 February 2022

2022-02-06T20:20:23Z

FuzzyBot: Importing a new version from external source

2021-08-03T23:41:04Z

Importing a new version from external source

New page

Recovers the model to an upright horizontal position – skids always to the ground – whenever is model under defined Hard Deck altitude. Rescue must be activated when flying but upon reaching low altitude it will take control of the model automatically. During lift off and landing it must be turned off. This recovery mode is great for beginners.

← Older revision		Revision as of 16:27, 16 September 2022
Line 1:		Line 1:
	Recovers the model to an upright horizontal position – skids always to the ground – whenever is model under defined Hard Deck altitude. Rescue must be activated when flying but upon reaching low altitude it will take control of the model automatically. During lift off and landing it must be turned off. This recovery mode is great for beginners.		Recovers the model to an upright horizontal position – skids always to the ground – whenever is model under defined Hard Deck altitude. Rescue must be activated when flying but upon reaching low altitude it will take control of the model automatically. During lift off and landing it must be turned off. This recovery mode is great for beginners.
−
−	~~VERY IMPORTANT: by activating the automatic save you can also use all the various functions of the Geolink unit except the “ALTITUDE LIMITED“ .~~
−	~~The Geolink function and the autosave from GT or GTR are completely independent, so you can't set anything wrong.~~
−	~~It is not possible to set the altitude limit from geolink and autosave from GT or GTR at the same time.~~
−	~~You can use all the other functions of Geolink except the altitude limit.~~

← Older revision		Revision as of 20:20, 6 February 2022
Line 1:		Line 1:
	Recovers the model to an upright horizontal position – skids always to the ground – whenever is model under defined Hard Deck altitude. Rescue must be activated when flying but upon reaching low altitude it will take control of the model automatically. During lift off and landing it must be turned off. This recovery mode is great for beginners.		Recovers the model to an upright horizontal position – skids always to the ground – whenever is model under defined Hard Deck altitude. Rescue must be activated when flying but upon reaching low altitude it will take control of the model automatically. During lift off and landing it must be turned off. This recovery mode is great for beginners.
		+
		+	VERY IMPORTANT: by activating the automatic save you can also use all the various functions of the Geolink unit except the “ALTITUDE LIMITED“ .
		+	The Geolink function and the autosave from GT or GTR are completely independent, so you can't set anything wrong.
		+	It is not possible to set the altitude limit from geolink and autosave from GT or GTR at the same time.
		+	You can use all the other functions of Geolink except the altitude limit.