(Created page with "Pokud již máte USB interface v počítači zapojen, je potřeba, aby byl druhý konec kabelu připojen do zdířky SYS v jednotce Spirit. Pro navázání spojení připojte...")
Pokud již máte USB interface v počítači zapojen, je potřeba, aby byl druhý konec kabelu připojen do zdířky SYS v jednotce Spirit. Pro navázání spojení připojte napájení jednotky. Pro napájení jednotky lze využít výstup z BEC, přijímače nebo baterie. Běžně se využívají dvě propojky kanálu RUD a AUX, kde prostřední vodič musí být kladný potenciál napájecího napětí, tedy plus (jednotka podporuje napětí 3 – 15V).
+
If you have already attached the USB interface to your computer, next
+
connect the interface cable to the '''SYS''' port of the Spirit FBL unit.
+
The Spirit FBL unit can not be powered from the USB cable/SYS port so it is
+
necessary to power it from either the receiver, a BEC or an external battery
+
pack.
+
The RUD and AUX ports are used to power the Spirit FBL unit and if using a BEC
+
or battery pack it is suggested to connect to these ports with a voltage
+
between 3V and 15V.
+
The middle wire must be the positive voltage connection.
Latest revision as of 11:16, 16 September 2016
If you have already attached the USB interface to your computer, next
connect the interface cable to the SYS port of the Spirit FBL unit.
The Spirit FBL unit can not be powered from the USB cable/SYS port so it is
necessary to power it from either the receiver, a BEC or an external battery
pack.
The RUD and AUX ports are used to power the Spirit FBL unit and if using a BEC
or battery pack it is suggested to connect to these ports with a voltage
between 3V and 15V.
The middle wire must be the positive voltage connection.