CC Phoenix Edge RPM Ausgang
From Spirit System Manual
Revision as of 15:22, 9 May 2018 by Buell47 (Talk | contribs) (Created page with "Erforderliche Änderung")
Castle Creations Phoenix ESCs sind mit einem RPM-Kabel ausgestattet, das das Signal für den externen Regler liefert. Sie müssen also nichts anderes tun, als die Kabel richtig anzuschließen und den internen Regler des ESC abzuschalten.
1 Erforderliche Änderung
For usage with the Spirit units a small modification of the RPM cable is needed.
- Move the White cable to the middle in the Servo connector.
- You can do so with a needle easily.
- Wire layout
- White wire: RPM Output Signal (PIT pin)
- Yellow wire: Throttle signal (AUX1 port)
- Red wire: BEC Voltage (AUX1 port)
- Brown wire: Ground (AUX1 port)
Connect the cables according the photo now.
2 Changing ESC settings
It is very important to change ESC mode so that internal Governor is disabled. This can be done by Castle Link software.
After this, you can enable Governor in the Spirit unit.
3 Governor Settings
In the Spirit Settings open the General - Throttle/Governor window and set the following:
- Throttle Frequency: 60Hz.
- Throttle Range - Min.: 1060 us.
- Throttle Range - Max.: 1940 us.