Difference between revisions of "Flashing Failed/es"
From Spirit System Manual
(Updating to match new version of source page) |
(Updating to match new version of source page) |
||
| Line 30: | Line 30: | ||
:#Conecte la interfaz USB a su PC y la unidad '''(SYS port)'''. | :#Conecte la interfaz USB a su PC y la unidad '''(SYS port)'''. | ||
:#Start the software. '''Select Recovery mode''' when prompted. | :#Start the software. '''Select Recovery mode''' when prompted. | ||
| + | :#Choose correct COM port in the Connection tab first. | ||
:#Go to the Update tab and select firmware you want to flash. | :#Go to the Update tab and select firmware you want to flash. | ||
:#Power up the unit (from your BEC or a battery). Status LED should pulsate. | :#Power up the unit (from your BEC or a battery). Status LED should pulsate. | ||
Revision as of 08:57, 4 October 2021
1 La unidad no funciona después de parpadear
In case that your unit is not operating correctly after flashing process, you can use the following guide to make it work again.
La pregunta importante es, ¿por qué fallo?
- Las posibilidades son:
- conexión entre la unidad y el ordenador no es estable (compruebe los cables).
- Bad USB interface driver in your Operating System.
Si está en Windows, reinstale el software con la opción de instalación del controlador. Entonces se instalará el controlador correcto. Luego reinicie el PC.
Si está en mac, utilice este controlador: OSX 11.0 Big Sur
Otros drivers muy probablemente no funcionarán correctamente - especialmente para el proceso de parpadear!
- Requirements for the Recovery process:
- Controlador correcto en su sistema operativo.
- Status LED of the unit must be pulsating after power up.
2 Cómo reactivar la unidad
- Conecte la interfaz USB a su PC y la unidad (SYS port).
- Start the software. Select Recovery mode when prompted.
- Choose correct COM port in the Connection tab first.
- Go to the Update tab and select firmware you want to flash.
- Power up the unit (from your BEC or a battery). Status LED should pulsate.
- Press the Flash button - Flashing process should start immediately.
- In 10 seconds, unit should be operating again without any issue. Your settings are untouched.
