Difference between revisions of "HobbyWing Platinum ESC v3/v4 RPM output"
From Spirit System Manual
| Line 17: | Line 17: | ||
; <translate>Wire layout</translate> | ; <translate>Wire layout</translate> | ||
: <translate>Yellow wire: RPM Output Signal (PIT pin)</translate> | : <translate>Yellow wire: RPM Output Signal (PIT pin)</translate> | ||
| − | : <translate>White wire: Throttle signal ( | + | : <translate>White wire: Throttle signal (AUX port)</translate> |
| − | : <translate>Red wire: BEC Voltage ( | + | : <translate>Red wire: BEC Voltage (AUX port)</translate> |
| − | : <translate>Black wire: Ground ( | + | : <translate>Black wire: Ground (AUX port)</translate> |
| − | |||
| − | |||
| − | |||
== <translate> | == <translate> | ||
Revision as of 11:39, 28 February 2017
HobbyWing ESCs v3/v4 are equipped with RPM lead that is providing signal for the external governor. So you do not need to do anything else except connect the cables properly and turn off the internal Governor of the ESC.
1 Required modification
For usage with the Spirit units a small modification of the RPM cable is needed.
- Move the Yellow cable to the middle in the Servo connector.
- You can do so with a needle easily.
- Wire layout
- Yellow wire: RPM Output Signal (PIT pin)
- White wire: Throttle signal (AUX port)
- Red wire: BEC Voltage (AUX port)
- Black wire: Ground (AUX port)
2 Governor Settings
In the Spirit Settings open the General - Throttle/Governor window and set the following:
- Throttle Frequency: 120Hz.
- Throttle Range - Min.: 1100 us.
- Throttle Range - Max.: 1940 us.
