View source for Hyperion RPM Sensor

<languages />
<p></p>
<translate>
Hyperion RPM Sensor is standard unit for measuring RPM from one phase wire.</translate>

[[File:hyperion-rpm-sensor.jpg|500px|]]

== <translate>
Required modification</translate> ==

<translate><!--T:3-->
For usage with the Spirit units a small modification of the RPM cable is needed.</translate>

*<translate><!--T:4-->
Move the White cable to the middle in a new Servo connector/plug.</translate>
*<translate><!--T:5-->
You can do so with a needle easily.</translate>

[[File:hyperion-rpm-mod.jpg|500px|]]

; <translate>
Wire layout</translate>
: <translate>White wire: RPM Output Signal (PIT pin)</translate>
: <translate>Red wire: BEC Voltage (AUX1/AUX2/CH0 or other power supply port)</translate>
: <translate>Brown wire: Ground (AUX1/AUX2/CH0 or other power supply port)</translate>

[[File:hyperion-rpm-connection.jpg|500px|]]

Connect the cables according the photo now.