View source for YGE ESC RPM output

== Wiring ==

=== YGE 40, YGE 60 ===

{| class="wikitable"
! Color
! Meaning
|-
| brown
| Ground
|-
| red
| Not connected
|-
| orange
| RPM-Signal
|}

{{Info|[[File:Info.png|18px]] Here you find the RPM-Signal on the split-cable.
It is important to connect the brown lead as well, to prevent extraneous radiation.}}


=== YGE 90LV, 120LV, 120LVK ===

{| class="wikitable"
! Color
! Meaning
|-
| brown
| Ground
|-
| red
| BEC (5,7V/7,4V/8V)
|-
| orange
| RPM-Signal
|}

{{Info|[[File:Info.png|18px]] Here you find the RPM-Signal on the split-cable (Slave).
It is important to connect the brown lead as well, to prevent extraneous radiation.}}


=== YGE 60HV, 90HV, 120HV, 160HV, 200HV, 320HV (all Optos without BEC) ===

{| class="wikitable"
! Color
! Meaning
|-
| brown
| Ground
|-
| red
| RPM-Signal
|-
| orange
| programming-Signal for ProgCard
|}

{{Info|[[File:Info.png|18px]] Here you find the RPM-output on the short ProgCard-cable.
It is important to connect the brown lead as well, to prevent extraneous radiation.
<br/>
Connect Orange wire to Ground for flying, to prevent extraneous radiation}}


== External Governor mode ==

{{Quote|For using external Governor with the YGE controllers, it's important to set the ESC to external governor mode!

* For our newest models, it's very easy. Just do the mode-setup and select Mode 1 (external Governor/Vbar Gov). Everything will be set to optimal parameters for use with FBL-governors and no ProgCard is needed.

* For older ESC's that don't have the mode-setup, a ProgCard is needed.
** Except for startup speed, program everything as usual.
** go to the second page of the ProgCard
** Set Startup speed to Heli middle and confirm with Enter.
** Select Gov off. and confirm 3x with Enter.
** Set Startup speed to plane middle and confirm with Enter. For confirmation you will hear another acknowledge sound as usual.
** Your ESC is now set to external Governor Mode!
** After programming, disconnect the main battery, ProgCard and patch cables.}}