First, set your desired ''collective range'', for example, +/-12°. We recommend
+
First, set your desired ''Collective range'', for example, +/-12°. We recommend
using a -100% to 100% linear collective pitch curve in the transmitter.
using a -100% to 100% linear collective pitch curve in the transmitter.
Now it is time to set the ''Aileron/Elevator'' maximum cyclic pitch range.<br />
Now it is time to set the ''Aileron/Elevator'' maximum cyclic pitch range.<br />
−
Try to set the largest possible deflection. This parameter does not directly affect the speed of rotation, but if it is too low, the model may not have consistent pitch and roll rates.
+
Try to set the largest possible deflection. Generally the Cyclic pitch angles (range) should be equal or lower than Collective pitch.
−
This setting should be done with 0° collective pitch. Then carefully check
+
This parameter does not directly affect the speed of rotation, but if it is too low, the model may not have consistent pitch and roll rates.
−
maximum stick deflection in all directions to ensure that mechanical binding
+
The setting should be done with 0° collective pitch. Then carefully move with sticks in all directions to ensure that mechanical binding
−
does not occur. This should also then be done with maximum and minimum collective pitch. Generally there is no reason to set deflection higher than maximum collective pitch angle. This parameter act as a so called ''Cyclic Ring''.
+
does not occur. This should also be done for the maximum and minimum Collective pitch.
Latest revision as of 00:25, 4 February 2018
First, set your desired Collective range, for example, +/-12°. We recommend
using a -100% to 100% linear collective pitch curve in the transmitter.
Now it is time to set the Aileron/Elevator maximum cyclic pitch range.
Try to set the largest possible deflection. Generally the Cyclic pitch angles (range) should be equal or lower than Collective pitch.
This parameter does not directly affect the speed of rotation, but if it is too low, the model may not have consistent pitch and roll rates.
The setting should be done with 0° collective pitch. Then carefully move with sticks in all directions to ensure that mechanical binding
does not occur. This should also be done for the maximum and minimum Collective pitch.