Difference between revisions of "Installation"
(Marked this version for translation) |
|||
| (2 intermediate revisions by the same user not shown) | |||
| Line 1: | Line 1: | ||
| − | <languages /> | + | <languages /> |
<div id="up"></div> | <div id="up"></div> | ||
<translate> | <translate> | ||
| Line 40: | Line 40: | ||
| − | <center> | + | <center><translate><!--T:16--> |
| − | Example 1:'' Position is '''Horizontal (180°)'''</translate></center> | + | ''Example 1:'' Position is '''Horizontal (180°)'''</translate></center> |
| Line 47: | Line 47: | ||
| − | <center> | + | <center><translate><!--T:8--> |
| − | Example 2:'' Position is '''Vertical (180° - left side)'''</translate></center> | + | ''Example 2:'' Position is '''Vertical (180° - left side)'''</translate></center> |
Latest revision as of 10:20, 12 October 2018
Properly mounting of Spirit plays an important role for the correct operation of your model.
Find a suitable location where vibrations are as low as possible - this is usually the same location shown by the manufacturer for mounting a gyro.
It is VERY important that the unit will be mounted so that the unit is exactly perpendicular to each rotational axis. Depending on your preference and available space it can be mounted in eight different positions:
- Horizontal (0°)
- Horizontal (180°)
- Horizontal (0° + inverted)
- Horizontal (180° + inverted)
- Vertical (0° - left side)
- Vertical (180° - left side)
- Vertical (0° - right side)
- Vertical (180° - right side)
In case the unit is positioned so that connectors are facing forwards, select 180°, please. If the unit is mounted upside down, select inverted option.
In the following photo the unit is mounted by double-sided adhesive tape to the frame of model.
In order to better insulate against any vibrations from the model, it is necessary
to choose the right double-sided mounting tape. The tape should limit any
transmission of vibrations from the model to the Spirit which may produce
undesirable flight characteristics.
Vibrations may also be caused by incorrectly balanced blades, damaged
bearings, bent shafts and other mechanical issues.
We recommend to use supplied double sided tape.
