Difference between revisions of "Hyperion RPM Sensor"
From Spirit System Manual
| Line 13: | Line 13: | ||
*<translate><!--T:4--> | *<translate><!--T:4--> | ||
| − | Move the White cable to the middle in | + | Move the White cable to the middle in a new Servo connector/plug.</translate> |
*<translate><!--T:5--> | *<translate><!--T:5--> | ||
You can do so with a needle easily.</translate> | You can do so with a needle easily.</translate> | ||
Revision as of 14:01, 12 April 2018
Hyperion RPM Sensor is standard unit for measuring RPM from one phase wire.
Required modification
For usage with the Spirit units a small modification of the RPM cable is needed.
- Move the White cable to the middle in a new Servo connector/plug.
- You can do so with a needle easily.
- Wire layout
- White wire: RPM Output Signal (PIT pin)
- Red wire: BEC Voltage (AUX1/AUX2/CH0 or other power supply port)
- Brown wire: Ground (AUX1/AUX2/CH0 or other power supply port)
Connect the cables according the photo now.
