Difference between revisions of "GeoLink Troubleshooting/es"
(Created page with "Solucion de problemas GEOLINK") |
(Created page with "En caso de un problema, GEOLINK notificara al piloto mediante un LED de estado incorporado. cualquier falla es señalada por un LED de estado parpadeante que se repite periodi...") |
||
| Line 1: | Line 1: | ||
<languages /> | <languages /> | ||
| − | + | En caso de un problema, GEOLINK notificara al piloto mediante un LED de estado incorporado. | |
| − | + | cualquier falla es señalada por un LED de estado parpadeante que se repite periodicamente. | |
| − | + | Si se produjo algun problema despues de una falla, se requiere la reparacion de GEOLINK. | |
LED flashing may show up immediately after power up. By number of LED blinks in series you can determine which problem is present. | LED flashing may show up immediately after power up. By number of LED blinks in series you can determine which problem is present. | ||
Revision as of 19:53, 22 January 2019
En caso de un problema, GEOLINK notificara al piloto mediante un LED de estado incorporado. cualquier falla es señalada por un LED de estado parpadeante que se repite periodicamente. Si se produjo algun problema despues de una falla, se requiere la reparacion de GEOLINK.
LED flashing may show up immediately after power up. By number of LED blinks in series you can determine which problem is present.
Contents
1 Failures
1.1 1x blink
Stored hardware data in GeoLink were lost. Contacting Spirit System support is necessary.
1.2 2x blink
Pressure sensor is not operating correctly. Usually this problem occur when GeoLink is operated for prolonged time under extremely high humidity conditions. Store GeoLink in low humidity environment for few hours until internal condensate will evaporate. If this will not help contact Spirit System support.
1.3 3x blink
Gyro, accelerometer sensors are not operating correctly. Contacting Spirit System support is necessary.
1.4 4x blink
Compass sensor is not operating correctly. Contacting Spirit System support is necessary.
1.5 Constant blinking
This might happen rather in-flight and could signalize unexpected failure. Most probable reason is shock by high electrostatic discharge.
2 Other notifications
In case that GeoLink is flashing and pilot can't access it through Spirit Settings then the following can be the reason.
2.1 Calibration process
If you can see 3 series of fast flashing (followed by fast erratic blinks) after power up of the GeoLink then the module is in so called Calibration process. This process can be invoked by pilot through Spirit Settings and must be finished according instructions. Until finished the GeoLink will be inoperable.
