Difference between revisions of "HobbyWing Platinum ESC v3/v4 RPM output/ru"
From Spirit System Manual
(Created page with "HobbyWing ESCs v3 / v4 оснащены проводом RPM, который выдает сигнал для внешнего гувернера. Поэтому вам не...") |
(Created page with "Необходимая переделка") |
||
| Line 6: | Line 6: | ||
[[File:hw-esc.jpg|500px]] | [[File:hw-esc.jpg|500px]] | ||
| − | == | + | == Необходимая переделка == |
For usage with the Spirit units a small modification of the RPM cable is needed. | For usage with the Spirit units a small modification of the RPM cable is needed. | ||
Revision as of 08:02, 16 October 2018
HobbyWing ESCs v3 / v4 оснащены проводом RPM, который выдает сигнал для внешнего гувернера. Поэтому вам не нужно ничего делать, кроме как правильно подключить провод и отключить внутренний гувернер ESC.
1 Необходимая переделка
For usage with the Spirit units a small modification of the RPM cable is needed.
- Move the Yellow cable to the middle in the Servo connector.
- You can do so with a needle easily.
- Wire layout
- Yellow wire: RPM Output Signal (PIT pin)
- White wire: Throttle signal (AUX1 port)
- Red wire: BEC Voltage (AUX1 port)
- Black wire: Ground (AUX1 port)
Connect the cables according the photo now.
2 Changing ESC mode
It is very important to change ESC mode so that internal Governor is disabled.
This can be made by a Multifunction LCD Program Box. Please see HobbyWing manual.
You can use the following modes:
- Helicopter (Linear Throttle) - great for beginners.
- Fixed-wing - great for advanced (will eliminate problems with slow spoolup and Autorotation Bailout feature).
After this, you can enable Governor in the Spirit unit.
3 Governor Settings
In the Spirit Settings open the General - Throttle/Governor window and set the following:
- Throttle Frequency: 120Hz.
- Throttle Range - Min.: 1100 us.
- Throttle Range - Max.: 1940 us.
