Difference between revisions of "Hyperion RPM Sensor/ru"
From Spirit System Manual
(Created page with "Hyperion RPM Sensor") |
(Created page with "Датчик оборотов Hyperion - типичное устройство измерения частоты вращения с однофазным подключен...") |
||
| Line 1: | Line 1: | ||
<languages /> | <languages /> | ||
<p></p> | <p></p> | ||
| − | Hyperion | + | Датчик оборотов Hyperion - типичное устройство измерения частоты вращения с однофазным подключением. |
[[File:hyperion-rpm-sensor.jpg|350px|]] | [[File:hyperion-rpm-sensor.jpg|350px|]] | ||
Revision as of 09:32, 16 October 2018
Датчик оборотов Hyperion - типичное устройство измерения частоты вращения с однофазным подключением.
Required modification
For usage with the Spirit units a small modification of the RPM cable is needed.
- Move the White cable to the middle in a new Servo connector/plug.
- You can do so with a needle easily.
- Wire layout
- White wire: RPM Output Signal (PIT pin)
- Red wire: BEC Voltage (AUX1/AUX2/CH0 or other power supply port)
- Black wire: Ground (AUX1/AUX2/CH0 or other power supply port)
Connect the cables according the photo now.
