Difference between revisions of "Hyperion RPM Sensor/ru"
From Spirit System Manual
(Created page with "Необходимая переделка") |
(Created page with "Для использования совместно со Spirit требуется небольшая модификация разъема RPM.") |
||
Line 7: | Line 7: | ||
== Необходимая переделка == | == Необходимая переделка == | ||
− | + | Для использования совместно со Spirit требуется небольшая модификация разъема RPM. | |
*Move the White cable to the middle in a new Servo connector/plug. | *Move the White cable to the middle in a new Servo connector/plug. |
Revision as of 09:32, 16 October 2018
Датчик оборотов Hyperion - типичное устройство измерения частоты вращения с однофазным подключением.
Необходимая переделка
Для использования совместно со Spirit требуется небольшая модификация разъема RPM.
- Move the White cable to the middle in a new Servo connector/plug.
- You can do so with a needle easily.
- Wire layout
- White wire: RPM Output Signal (PIT pin)
- Red wire: BEC Voltage (AUX1/AUX2/CH0 or other power supply port)
- Black wire: Ground (AUX1/AUX2/CH0 or other power supply port)
Connect the cables according the photo now.