Difference between revisions of "Hyperion RPM Sensor/hu"
From Spirit System Manual
(Created page with "Hyperion RPM érzékelő") |
(Created page with "A Hyperion RPM érzékelő szabványos 1 vezetékes fordulatszám mérő") |
||
| Line 1: | Line 1: | ||
<languages /> | <languages /> | ||
<p></p> | <p></p> | ||
| − | Hyperion RPM | + | A Hyperion RPM érzékelő szabványos 1 vezetékes fordulatszám mérő |
[[File:hyperion-rpm-sensor.jpg|350px|]] | [[File:hyperion-rpm-sensor.jpg|350px|]] | ||
Revision as of 11:50, 8 September 2020
A Hyperion RPM érzékelő szabványos 1 vezetékes fordulatszám mérő
Required modification
For usage with the Spirit units a small modification of the RPM cable is needed.
- Move the White cable to the middle in a new Servo connector/plug.
- You can do so with a needle easily.
- Wire layout
- White wire: RPM Output Signal (PIT pin)
- Red wire: BEC Voltage (AUX1/AUX2/CH0 or other power supply port)
- Black wire: Ground (AUX1/AUX2/CH0 or other power supply port)
Connect the cables according the photo now.
