From Spirit System Manual
|
|
| Line 1: |
Line 1: |
| − | <languages />
| + | asdas |
| − | <p></p>
| + | |
| − | | + | |
| − | <translate><!--T:1-->
| + | |
| − | This sensor is HALL type which senses RPM by motion of the rotating magnets.
| + | |
| − | Usually 1 - 2 neodymium magnets are mounted on the fan of combustion helicopters with a Nitro motor.</translate>
| + | |
| − | | + | |
| − | [[File:Spirit-sensor.jpg]]
| + | |
| − | | + | |
| − | ; <translate><!--T:6-->
| + | |
| − | Wire layout</translate>
| + | |
| − | : <translate><!--T:7-->
| + | |
| − | Orange wire: RPM Output Signal</translate>
| + | |
| − | : <translate><!--T:8-->
| + | |
| − | Red wire: Ground</translate>
| + | |
| − | : <translate><!--T:9-->
| + | |
| − | Brown wire: 3.3V - 15V</translate>
| + | |
| − | | + | |
| − | | + | |
| − | <translate>Wiring Example</translate>
| + | |
| − | [[File:SpiritSensor-connection.jpg|center|thumb]]
| + | |
| − | | + | |
| − | == <translate><!--T:15-->
| + | |
| − | Magnet mounting</translate> ==
| + | |
| − | | + | |
| − | <translate><!--T:16-->
| + | |
| − | We highly recommend to orientate each magnet as '''Active''' for a proper operation.
| + | |
| − | More magnets will result in a higher reading resolution thus increased readout precision.</translate>
| + | |
| − | | + | |
| − | == <translate><!--T:17-->
| + | |
| − | Governor Settings</translate> ==
| + | |
| − | | + | |
| − | <translate><!--T:18-->
| + | |
| − | When sensor is connected, please set the ''Sensor Divider'' parameter so that the value will represent count of the active magnets.
| + | |
| − | Usually it is 1 or 2 magnets.</translate>
| + | |
| − | | + | |
| − | [[File:<translate><!--T:19-->
| + | |
| − | Gov-divider.png</translate>|center|thumb]]
| + | |
Revision as of 11:38, 23 November 2021
asdas
