HobbyWing Platinum ESC v3/v4 Drehzahl-Ausgang

HobbyWing ESCs v3/v4 sind mit RPM-kabel ausgestattet, der das Signal für den externen Regler liefert. Sie brauchen also nichts anderes zu tun, außer die Kabel richtig anzuschließen und den internen Governor des ESCs auszuschalten.

1 Erforderliche Änderung

For usage with the Spirit units a small modification of the RPM cable is needed.

• Move the Yellow cable to the middle in the Servo connector.
• You can do so with a needle easily.

Wire layout

Yellow wire: RPM Output Signal (PIT pin)

White wire: Throttle signal (AUX1 port)

Red wire: BEC Voltage (AUX1 port)

Black wire: Ground (AUX1 port)

Connect the cables according the photo now.

2 Changing ESC mode

It is very important to change ESC mode so that internal Governor is disabled.

This can be made by a Multifunction LCD Program Box. Please see HobbyWing manual.

You can use the following modes:

• Helicopter (Linear Throttle) - great for beginners.
• Fixed-wing - great for advanced (will eliminate problems with slow spoolup and Autorotation Bailout feature).

After this, you can enable Governor in the Spirit unit.

3 Governor Settings

In the Spirit Settings open the General - Throttle/Governor window and set the following:

• Throttle Frequency: 120Hz.
• Throttle Range - Min.: 1100 us.
• Throttle Range - Max.: 1940 us.