Integrace HoTT
Od verze 2.3 jednotky Spirit podporují plnou integraci s vysílači Graupner HoTT. Znamená to, že lze konfigurovat jednotky Spirit zcela prostřednictvím rádia bez nutnosti připojení počítače.
Integrace funguje se všemi HoTT přijímači a vysílači kromě modelů MZ-4 a MZ-8.
Contents
1 Zapojení
Pro fungování integrace je zapotřebí připojit tzv. HoTT propojku. Umožní spojit telemetrický port přijímače s portem jednotky SYS. Ve výsledku jsou mezi jednotkou a přijímačem dva druhy spojení:
- Přenos kanálů (PWM, PPM nebo SUMD)
- Přenos dat telemetrie a integrace
Použijte HoTT propojku dostupnou v naší nabídce obchodu. Zapojte ji dle následujících kroků:
- Černý servo konektor připojte do přijímače do portu telemetrie (ozančen popiskem T).
- Červený servo konektor připojte do jednotky na pozici SYS.
It is very important to pay attention during the connection!
If connected wrongly, it will damage the unit permanently. The cable end where red wire is in the middle pin must be always connected to the unit. Never use other cables for this connection!
Servo connector in the Graupner Hott receivers is connected so that the signal wire is at the bottom.
2 Receiver configuration
Make sure that your Receiver has enabled Telemetry output. This port is deactivated in the Factory defaults.
Go to the Function (F)/Telemetry/Setting & Data View where you have to change option SENSOR at CHx to YES.
To enter the Menu you have to enter Function (F)/Telemetry/Setting & Data View. The unit is emulating General Air Module sensor by default. So in the Menu you have to see, that the GENE (General) is active. Then you have to press the GENE (General) button (MZ series) to switch to this sensor type - transmitter will start to listen responses from the Spirit unit. If you are using HoTT MX series transmitter, you have to change sensor type with the arrows on the left side to General.
Then use the ENT button (MZ series) or right arrow on the right side (MX series) to reach the SPIRIT SYSTEM page.
4 Sensor Emulation
In case that you are already using General Air Module module, you can change it to another in the integration menu. In the Advanced/Expert settings/HoTT Sensor you can change the module emulation.
Available types are:
- GAM - General Air Module
- EAM - Electric Air Module
5 Telemetry data
With this connection the Spirit will not only offer the Integration, but also a various telemetry data. These data can be displayed on your main screen and even logged during flight.
With the Spirit firmware 2.3.0 you are able to view:
- Current RPM from the Governor.
- Vibrations of the model (Reported as Fuel in the GAM)
To view the values you only have to switch Telemetry data source to General.
