SpiritRS Preparation

To operate Spirit RS unit any JETI DUPLEX radio can be used.

Supported radios are:

• DC-14
• DC-16
• DC-16 II
• DC-24
• DS-12
• DS-14
• DS-16
• DS-24

We recommend to start with clear model profile as you will need only few changes.

Spirit System offer DS-12 radio tailored specially for the Spirit RS. This mean you will be able to utilize completely all features out of the box.

1 Beginning

First from all you should carefully read radio manual. Once you understand all the particulars you can change Mode if needed. This is fully described in the included manual. When securing bottom cover after Mode change please pay extra attention that no cable is in way of a screw.

Secondly remove cover made of foil from display.

2 Turning On and Off

By pressing Power button you should be able to start the radio. If not, please use supplied charger and charge the battery. By pressing the Power button again, you can turn radio off.

3 New Profile

If you are new to the JETI radios, please proceed according following steps.

3.1 Profile creation

Start the radio and press MENU button. Then enter the Model menu by pressing the Rotary knob.

Select New Model, enter name of the Model and select Heli type. Then continue by pressing right button under display.

Model Image & Colors Menu can be optionally configured according your preference. Continue to another page by pressing button under display.

In the Basic Properties menu select Heli to Spirit and continue to another page. (Please note transmitter update 5.03 is required for this option).

Confirm until you will be prompted to Create and activate model. Select Yes.

3.2 Basic Helicopter settings

Open Heli Tuning menu - Main Menu/Heli Tuning.

3.2.1 Flight Modes

Enter Flight Modes menu and press Yes when prompted "Created flight modes?".

Assign switch for Autorot. mode - usually it is two-state switch called Sc at the left front side of the radio. This switch will be used for Throttle Hold/Autorotation.

Assign switch for all Idle modes - usually it is tri-state switch called Sa above Sc.