Hott Integration

From version 2.3 the Spirit units support full integration with the Graupner HoTT transmitters. This mean that you can configure the Spirit units completely from your radio wihtout need of a computer.

The integration can work with all HoTT receivers and radios except MZ-4 and MZ-8.

Wiring

To allow the integration you have to connect additional cable to your current setup. This cable will connect the Telemetry port of the receiver with the SYS port of the unit. So there should be two connections between unit and receiver for:

• Channel transmission (PWM, PPM or SUMD)
• Telemetry data

Use the Hott Integration cable available in our eshop.

It is very important to pay attention during the connection!
If connected wrongly, it will damage the unit permanently. The cable end where Orange wire is in the middle pin must be always connected to the unit.