Проблемы и решения.

Описание проблемы	Решение
Тарелка или хвост уплывают после инициализации.	Проверьте триммеры и субтриммеры. Стики в центральном положении должны давайть 0%, см. Вкладку Диагностика. Увеличьте Мертвую зону стика на вкладке Дополнительно.
Неточное управление цикликом или хвостом.	Увеличьте Циклическую чувствительность и / или увеличьте Чувствительность хвоста в передатчике. Увеличьте экспоненту в передатчике.
Агрессивная работа шагом или быстрый пролет вперед приводят к быстрым и сильным колебаниям хвоста.	Уменьшайте постепенно Постоянство скорости пируэта на вкладке Дополнительно постепенно на 10, пока проблема не исчезнет. Проверьте механику хвоста на предмет плавности работы.
Model oscillates in elevator or aileron axes	Decrease cyclic gain in Sensor tab.
Tail oscillates rapidly	Decrease gyro gain in the transmitter.
Flips and rolls are too slow or too fast	Increase/decrease rotation speed for Cyclic in the Sensor tab.
Pirouette is too slow/fast	Increase/decrease rotation speed for Rudder in the Sensor tab.
Servos jitter randomly without external influences	Check the cable connection between the receiver and the unit.
During stationary pirouettes model drifts	Check the Subtrim configuration in the Servos tab. It seems to be inprecise.
Aggressive elevator stick movement leads to bouncing	Increase elevator filter in Advanced tab and/or decrease cyclic feed forward in Advanced tab.
Cyclic feel is delayed or disconnected	Increase cyclic feed forward in Advanced tab.
Elevator servo is not moving when initialization is finished	Flight log from the previous flight was saved. View the log in the Diagnostic tab and fix reported problem.
Swashplate is jumping in a cycle when initialization is finished	The unit was started with the Rescue mode engaged. Turn off the rescue from your transmitter.
Rudder stop is not equal for both sides	Check rudder servo center position, rudder mechanics. You can also try to lower rudder limit for the side where bounce-back occur.
Positive and negative collective pitch is unequal	Enable Servos/Subtrim (tuning) and verify that servo arms are perpendicular, swashplate perfectly leveled and there is 0° between main blades. If yes, use the Servo Travel Correction.
Castle ESC is not arming	Set General - Throttle/Governor - Throttle Range Min. to 1060µs and Max. to 1940µs.
RPM readout is not correct with the ESC Telemetry	Temporarily enable General - Throttle/Governor - Governor and set Sensing Divider and Gear Ratio. Then turn the Governor off if governor from ESC is used.