Nastavení

From Spirit System Manual
Revision as of 19:30, 3 June 2020 by Admin (Talk | contribs) (Created page with "Výrazně doporučujeme neprovádět nastavení během létání! Pokud byla otevřená integrace, vždy ji poté uzavřete zvolením Zavřít menu.")

Jump to: navigation, search

Všechny jednotky spirit lze nastavovat prostřednictvím vysílače. Není tedy zapotřebí počítač. Jednotku Spirit RS lze celou konfigurovat a upravovat veškeré letové parametry, jednoduše v menu Připojená zařízení.

1 Integrace Spirit

Integrace Spirit je rozhraní, které umožnuje nastavovat jednotky Spirit. Jakékoli změny v nastavení týkající se jednotky Spirit RS lze provést zde. Do rozhraní je navíc možné vkročit kdykoli je to zapotřebí.

Info.png Výrazně doporučujeme neprovádět nastavení během létání! Pokud byla otevřená integrace, vždy ji poté uzavřete zvolením Zavřít menu.

1.1 Opening Spirit menu

To open Spirit setup you can proceed in the following way.

Open Spirit menu in the Model/Heli Tuning.

Jeti-spiritmenuop.png Jeti-spiritmenu.png

Info.png In case you are getting error message when opening the integration menu, please install the latest JETI integration file - available at our web pages.
SPIRIT-3.X.zip archive must be extracted and all the files copied to the Devices directory inside your Radio.

1.2 Spirit Settings

Spirit menu is almost identical to computer software called Spirit Settings that can be also optionally used.

You can easily change any parameter and changes are applied immediately. But to store any changes do not forget to Save the settings.

Info.png Click at the Save Settings in the Spirit menu to save all changes you have made in the Spirit RS settings. Otherwise after re-power changes are returned to the previous values.

1.3 Closing Spirit menu

To continue with flying please close the Spirit menu by selecting Close the integration menu. Once this is performed, Status LED of the unit must remain steady On.

2 Configuring Receiver part

To configure E1 telemetry port you can open Device Explorer and perform settings there.

Open Menu and press right button under display. This will open Device Explorer instantly. Alternatively you can go trough Model/Device Explorer menu.

Then select REX-RS device. All changes in the settings are saved immediately.

Jeti-devrexrs.png

3 Spirit RS setup

To prepare Spirit unit for flight it is necessary to go through Setup Wizard first. This process is required only once, always for a new model.

You can find the Setup Wizard in the Spirit Integration menu.

Jeti-wizard.png Jeti-wizard2.png