Spirit RX
From Spirit System Manual
Revision as of 08:24, 16 October 2024 by Admin (Talk | contribs) (Created page with "Spirit RX is bi-directional transmission protocol developed by Spirit System for Spirit Wave radio system. It features support for tranmitting channel data, telemetry data, i...")
Spirit RX is bi-directional transmission protocol developed by Spirit System for Spirit Wave radio system.
It features support for tranmitting channel data, telemetry data, integration data and even OTA update over a single BUS.
All Spirit units have support for this protocol. You can connect Spirit RX7 receiver that has support for Spirit RX protocol.
1 Wiring
1.1 Spirit GT, GTR
Spirit GT unit require only a direct cable between RUD port and port 2 X of the Wave receiver such as Spirit RX7.
1.2 Spirit 1, Spirit 2, Spirit RS, Spirit Pro, microSpirit =
You will need JETI Integration Cable connected at the RUD port (Red and Brown wires) + AIL pin (Orange wire) at the Spirit side, while second end of the cable must be connected at the port 2 X of the Wave receiver such as Spirit RX7.
