Spirit RX Wiring

1 Wiring

You can optionally connect Spirit RX receivers with Spirit units. Wiring is simple and allows the best integration through our own Spirit RX protocol.

1.1 Spirit GT

Spirit GT unit require only a direct cable between RUD port and port 2 X of the Wave receiver.

1.2 Spirit W1

Spirit W1 unit require only a direct cable between T1 port and port 2 X of the Wave receiver.

1.3 Spirit 1, Spirit 2, Spirit Pro, Spirit RS, Spirit GTR, microSpirit

You will need JETI Integration Cable connected at the RUD port (Red and Brown wires) + AIL pin (Orange wire) at the Spirit side, while second end of the cable must be connected at the port 2 X of the Wave receiver.

2 Spirit Settings

In order for both devices to communicate you need to set Receiver Type to Spirit RX option in the Spirit units.