Difference between revisions of "SpiritW1 Binding"
From Spirit System Manual
| (One intermediate revision by the same user not shown) | |||
| Line 1: | Line 1: | ||
<languages/> | <languages/> | ||
| − | = | + | =4 <translate><!--T:2--> |
Binding Procedure</translate> = | Binding Procedure</translate> = | ||
| Line 15: | Line 15: | ||
[[File:spritW1-bind.jpg|class=halfwidth|center]] | [[File:spritW1-bind.jpg|class=halfwidth|center]] | ||
| − | |||
== Manual Binding == | == Manual Binding == | ||
| − | |||
You can Bind manually by going to the '''Model/Receiver''' menu. | You can Bind manually by going to the '''Model/Receiver''' menu. | ||
Press the '''Bind button''' after powering up Spirit W1 with a Bind plug. | Press the '''Bind button''' after powering up Spirit W1 with a Bind plug. | ||
[[File:wave-bind.png|480px|center]] | [[File:wave-bind.png|480px|center]] | ||
| − | |||
<div class=noprint> | <div class=noprint> | ||
Latest revision as of 12:47, 11 January 2024
1 4 Binding Procedure
In order to Bind Spirit W1 with your Wave radio use supplied Bind plug.
- Insert Bind plug at the SYS port and connect Power supply to the Spirit W1 unit. You can connect BEC or 1-3S Battery at the THR, AUX, T1 ports.
- Spirit W1 unit will start to blink with the Status LED periodically.
- Then power up your Wave radio.
- Radio will automatically bind to the receiver when using new Model profile. You can also Bind anytime manually as described in the section above.
- After successfull binding Spirit unit will stop blinking and will initialize. Then you can remove the Bind plug.
1.1 Manual Binding
You can Bind manually by going to the Model/Receiver menu. Press the Bind button after powering up Spirit W1 with a Bind plug.
