Difference between revisions of "CrossFire CRSF"

From Spirit System Manual
Jump to: navigation, search
Line 46: Line 46:
 
== RadioMaster CRSF Settings ==
 
== RadioMaster CRSF Settings ==
  
In order to make RM receivers working well we recommend following settings:
+
In order to make RM receivers working well we recommend following settings. These settings can be adjusted at the CROSSFIRE SETUP menu.
  
 
=== RM Ranger ===
 
=== RM Ranger ===
Line 54: Line 54:
  
 
=== RM RPH-3 ===
 
=== RM RPH-3 ===
* Init Rate: F1000
+
* Init Rate: '''F1000'''

Revision as of 14:07, 5 December 2024

CrossFire CRSF is protocol designed by Team Blacksheep (TBS) which is supported by all Spirit units except Spirit 1 and micro Spirit. It is for sending all channel data and telemetry at the same time. This mean that you do not have to connect anything else except 4 wires.

There are multiple receivers and satellites with CrossFire CRSF support.

Both cable ends can look like this:

CRSF-Wiring.jpg

1 Wiring

1.1 CrossFire TBS

CRSF-Wiring2.jpg CRSF-Wiring3.jpg

RUD port - direct cable between CRSF RX Ch. Out 1

AIL pin (pin closer to the port label) - wire to CRSF RX Ch. Out 2 signal pin

1.2 RadioMaster ELRS

CRSF-Wiring4.jpg

2 Spirit Settings

Now you are ready to power up the unit. If your Power supply is not connected yet, we recommend to connect it to the AUX1, AUX2 and/or CH0 port. Before you can utilize the CrossFire connection, it is important to set the CrossFire CRSF receiver type in the General tab of the software. Please start the Spirit Settings and change the receiver type as displayed on the photo. Then save the settings (e.g. by CTRL+S) or the Backup tab/Unit - Save and restart the unit.

CRSF-settings.png

3 Throttle output

You can connect ESC or Throttle servo directly to the Spirit unit at (AUX/AUX1 port).

4 Radio Integration

Integration support is to be added within following updates.

5 RadioMaster CRSF Settings

In order to make RM receivers working well we recommend following settings. These settings can be adjusted at the CROSSFIRE SETUP menu.

5.1 RM Ranger

  • Packet Rate: 100Hz Full
  • Telem Ratio: 1:2
  • Switch Mode: 8Ch

5.2 RM RPH-3

  • Init Rate: F1000