Difference between revisions of "Kontronik Telemetry/de"

Revision as of 11:53, 20 August 2017

Kontronik KOSMIK und JIVE PRO ESC verfügt über eine Telemetrie-Funktion, die in einem dedizierten Telemetrie-Anschluss eingebaut ist. Dies ermöglicht eine telemetrische Datenübertragung an das Gerät.

Diese Telemetrie steht nur für die EX-Bus Verbindung mit der Spirit Firmware v2.4 zur Verfügung. In den zukünftigen Versionen sollte es auch mit anderen funktionieren.

1 Telemetriekabel

Um die Telemetrie-Datenübertragung zu ermöglichen, ist das Telem KONTRONIK-Kabelerforderlich. Dieses Kabel ist in unserem Eshop erhältlich.

2 Spirit Settings

First from all, power up the ESC and start the Spirit Settings as usually.

2.1 Telemetry activation

Set the ESC Telemetry in the Spirit Settings software.

Go to the Advanced/Telemetry settings and set the Kontronik KOSMIK & JIVE PRO option.

Then close the window and save the settings (CTRL+S). Now disconnect the battery.

3 Interfacing

At this step, connect the Telemetry cable according the following photo.

In this connection SYS port is used. Thus usage of this port for other purposes is limited when the Kontronik telemetry is enabled. Jeti Integration is still available for full configuration of the unit. If you need to use Spirit Settings software, you can deactivate temporarily ESC Telemetry by not turning transmitter on. At this moment normal connection for the USB interface or Wireless connection is established.
ELE pin is utilized for communication purpose of the telemetry interface.

4 Displaying telemetry data

When previous steps were finished, you are ready to power up the battery.

After initialization you can display all telemetry data directly in your radio from now.

How to display the data is described in the integration guide:

• JETI Duplex

5 Supported models